ON THIS WIKI
|Source Mod||Thermal Dynamics|
|ID Name|| |
|Affected by Gravity||No|
|Emits Light||With Lava inside|
The Temperate Fluiduct is a block added by the Thermal Dynamics mod. Used to transport liquids. Compatible with most mods' machines and Tanks. Some machines such as the Aqueous Accumulator or Pump and some tanks such as a Portable Tank  will output to a connected Fluiduct automatically. The Fluiduct has an Opaque version that removes the ability to see the liquid inside, it is cheaper to make and may reduce lag. Opaque Fluiduct will still connect to regular Fluiducts. The transfer rate vary with the liquid tranported. This Fluiduct will break if transporting extreme temperature liquids. The Fluiduct can carry only one type of liquid at a time and will not accept a different type unless completely empty.
The type of fluid extracted may be filtered and Redstone control activation setting changed using a Servo  or a Retriever to extract from a remote source. 'Right-clicking' the Fluiduct connection with the Servo will install it, 'Right-clicking' again will open the GUI, where the Redstone signal setting may be changed to Disabled, Low or High. A ghost image of a fluid can be added to the filter inventory (using a bucket) and set to White or Black list.
The rate at which Fluiducts transfer their contents depends on the fluid transported and is calculated with the formula:
Where Rate of Flow is a value restricted to be between 80 and 600 mB per tick. The table below list some common fluids and their transfer rates (as with all Thermal Dynamics ducts, the transfer rate is per connection):
|Fluid||Viscosity|| Transfer Rate |
UsageTemperate Fluiduct can be used to create the following items:
The following items may also be of interest:
- A Servo or Retriever is needed to extract from the side of a Portable Tank.
- When Removing the Fluiduct the liquid inside will be lost.
- A Filter may also be used on the receiving end [of a Servo] if the Duct system is used for multiple liquids and/ or outputs.