24,302 ARTICLES
ON THIS WIKI

External Heater

External Heater
External Heater

Name External Heater
Source Mod Immersive Engineering
ID Name Unknown
First Appearance MC 1.7.10
Type Block
Stackable Yes (64)
Solid Yes
Transparent No
Affected by Gravity No
Emits Light No
Flammable No
Required Tool Any tool will work, but a pickaxe is the most efficient.

The External Heater is a block added by Immersive Engineering. The External Heater uses RF to power a Vanilla Minecraft furnace.

To use the External Heater place it directly next to the furnace, then using the Engineer's Hammer right click on the External Heater to turn the input port (a yellow square spot) on the side clicked on, sneaking and right clicking turns on the opposite side, and place power on the input port. Once powered use the Vanilla Minecraft furnace to smelt as one would normally, but without needing to place burnable materials, such as Coal or Wood Planks, in the bottom slot of the furnace.

The External Heater initially uses 32 RF/t to heat the furnace until it reaches maximum temperature then it will only use 8 RF/t to maintain the temperature. When smelting at maximum temperature the External Heater will use 32 RF/t (an additional 24 RF/t to the 8 RF/t needed) to double the speed of smelting.

The External Heater can be kept on by using a redstone signal.

Recipe[edit]

GUI Crafting Table.png
Iron Ingot
Copper Ingot (Immersive Engineering)
Iron Ingot
Copper Ingot (Immersive Engineering)
Copper Wire Coil
Copper Ingot (Immersive Engineering)
Iron Ingot
Redstone
Iron Ingot
External Heater

Usage[edit]

External Heater can be used to create the following items: